Aluminium
Aluminium
[Insert dimensions]
[Insert thread type]
Up to [Insert temperature range]
E3D V6 J-head 3D printing hotend
Installation and Maintenance
| To ensure optimal performance and longevity, follow these guidelines |
By integrating the Aluminium Heat Block for E3D V6 J-head 3D Printer into your printing setup, you can expect improved thermal performance, enhanced print quality, and reduced risk of hotend failure.
Aluminium Heat Block for E3D V6 J-head 3D Printer DocumentationOverviewThe Aluminium Heat Block for E3D V6 J-head 3D Printer is a high-performance heat block designed for the E3D V6 J-head 3D printer. This heat block is made of high-quality aluminum alloy, ensuring excellent heat conductivity and durability. It is designed to provide consistent and reliable heating performance, making it an essential component for 3D printing applications.SpecificationsMaterial: Aluminum alloy
Compatibility: E3D V6 J-head 3D printer
Dimensions: 20mm x 20mm x 10mm (L x W x H)
Thermal performance: up to 300C
Threads: M6 x 1.0Code Examples### Example 1: Temperature Control using ArduinoThis example demonstrates how to use the Aluminium Heat Block with an Arduino board to control the temperature of the hotend.```c
#include <Arduino.h>// Define the pin for the temperature sensor
const int tempSensorPin = A0;// Define the pin for the heater
const int heaterPin = 9;void setup() {
// Initialize the serial communication
Serial.begin(9600);// Initialize the heater pin as an output
pinMode(heaterPin, OUTPUT);
}void loop() {
// Read the temperature from the sensor
int tempReading = analogRead(tempSensorPin);
float temperature = tempReading 5.0 / 1024.0;// Set the target temperature
float targetTemp = 200.0;// Calculate the error
float error = targetTemp - temperature;// Control the heater
if (error > 0) {
digitalWrite(heaterPin, HIGH);
} else {
digitalWrite(heaterPin, LOW);
}// Print the temperature
Serial.print("Temperature: ");
Serial.print(temperature);
Serial.println(" C");// Wait for 1 second
delay(1000);
}
```### Example 2: Marlin Firmware ConfigurationThis example demonstrates how to configure the Marlin firmware to use the Aluminium Heat Block with the E3D V6 J-head 3D printer.```c
// Marlin firmware configuration// Define the temperature sensor type
#define TEMP_SENSOR_TYPE 1// Define the heater pin
#define HEATER_PIN 2// Define the temperature sensor pin
#define TEMP_SENSOR_PIN A0// Define the maximum temperature
#define MAX_TEMP 300// Define the bed heating settings
#define BED_HEATING 1
#define BED_HEAT_PIN 3
#define BED_TEMP_SENSOR_PIN A1// Define the hotend heating settings
#define HOTEND_HEATING 1
#define HOTEND_HEAT_PIN 2
#define HOTEND_TEMP_SENSOR_PIN A0
```Note: These examples are for illustrative purposes only and may require modifications to work with your specific 3D printing setup. Ensure to follow proper safety guidelines and best practices when working with high-temperature components.