YX-3600TREB Analog Multimeter Documentation
The YX-3600TREB is a high-precision analog multimeter designed for measuring various electrical parameters such as voltage, current, resistance, and continuity. This device is ideal for professionals and hobbyists alike, offering accurate readings and a compact design.
Measurement ranges:
+ Voltage: 0-1000V AC/DC
+ Current: 0-10A AC/DC
+ Resistance: 0-20M
+ Continuity: Beep and LED indication
Accuracy: (0.5% + 1 digit) for voltage and current, (1.0% + 1 digit) for resistance
Power supply: 3x AAA batteries (included)
Operating temperature: -10C to 40C
### Example 1: Arduino Integration - Voltage Measurement
In this example, we will demonstrate how to use the YX-3600TREB with an Arduino board to measure voltage.
Arduino Board (e.g., Arduino Uno)
YX-3600TREB Analog Multimeter
Jumper wires
Code:
```c
const int analogInPin = A0; // Analog input pin for voltage measurement
int sensorValue = 0; // Variable to store the analog reading
void setup() {
Serial.begin(9600);
}
void loop() {
sensorValue = analogRead(analogInPin);
float voltage = sensorValue (5.0 / 1023.0); // Convert analog reading to voltage
Serial.print("Voltage: ");
Serial.print(voltage);
Serial.println(" V");
delay(1000);
}
```
Note: In this example, we are using the `analogRead()` function to read the analog voltage value from the YX-3600TREB, which is connected to the analog input pin A0. The voltage value is then calculated and printed to the serial monitor.
### Example 2: Raspberry Pi Integration - Resistance Measurement
In this example, we will demonstrate how to use the YX-3600TREB with a Raspberry Pi to measure resistance.
Raspberry Pi (e.g., Raspberry Pi 4)
YX-3600TREB Analog Multimeter
Jumper wires
Resistor (e.g., 1k)
Code:
```python
import time
import RPi.GPIO as GPIO
GPIO.setmode(GPIO.BCM)
GPIO.setup(17, GPIO.IN, pull_up_down=GPIO.PUD_UP) # Set GPIO 17 as input for resistance measurement
while True:
resistance_value = GPIO.input(17) # Read the resistance value
if resistance_value == 1:
print("Resistance: ", end="")
print("Open circuit or infinite resistance")
else:
resistance = (float(1023) / resistance_value) 1000 # Convert resistance value to k
print("Resistance: {:.2f} k".format(resistance))
time.sleep(1)
```
Note: In this example, we are using the `RPi.GPIO` library to read the resistance value from the YX-3600TREB, which is connected to GPIO pin 17. The resistance value is then calculated and printed to the console.
These examples demonstrate the versatility of the YX-3600TREB Analog Multimeter and its ease of integration with popular microcontrollers and single-board computers.
